Cisco Small Business 300 1.1 Series Administration Manual page 325

Address Table Commands
78-20269-01 Command Line Interface Reference Guide
Parameters
•
mac-multicast-address—Specifies the group MAC multicast address.
•
add—Adds ports to the group.
•
remove—Removes ports from the group.
•
ethernet interface-list—Specifies a list of Ethernet ports. Separate
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel port-channel-list—Specifies a list of port channels. Separate
nonconsecutive port-channels with a comma and no spaces; use a hyphen
to designate a range of port channels.
Default Configuration
No multicast addresses are defined.
If ethernet interface-list or port-channel port-channel-list is specified without
specifying add or remove, the default option is add.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
To register the group in the bridge database without adding or removing ports or
port channels, specify the mac-multicast-address parameter only.
Static multicast addresses can be defined on static VLANs only.
You can execute the command before the VLAN is created.
Example
The following example registers the MAC address to the bridge table:
Console(config)#
interface vlan
Console(config-if)#
The following example registers the MAC address and adds ports statically.
8
bridge multicast address 01:00:5e:02:02:03
27
326