Lldp Med Network-Policy (Interface) - Cisco Small Business 300 1.1 Series Administration Manual

Link Layer Discovery Protocol (LLDP) Commands
78-20269-01 Command Line Interface Reference Guide
Example
This example creates a network policy for the voice-signally application and
attaches it to port 1. LLDP packets sent on port 1 will contain the information
defined in the network policy.
console(config)# lldp med network-policy 1 voice-signaling vlan 1 vlan-type
untagged up 1 dscp 2
Console(config)#
interface gi1
Console(config-if)#

44.17 lldp med network-policy (interface)

Use the lldp med network-policy Interface Configuration (Ethernet) mode
command to attach or remove an LLDP MED network policy on a port. Network
policies are created in
Use the no form of this command to remove all the LLDP MED network policies
from the port.
Syntax
lldp med network-policy
no lldp med network-policy
Parameters
•
number—Specifies the network policy sequential number. The range is
1-32
•
number
add/remove
the interface.
Default Configuration
No network policy is attached to the interface.
Command Mode
Interface Configuration (Ethernet) mode
lldp med network-policy add
lldp med network-policy
{add | remove} number
number
—Attaches/removes the specified network policy to
1
(global).
44
662