Cisco Small Business 300 1.1 Series Administration Manual page 330

Address Table Commands
78-20269-01 Command Line Interface Reference Guide
Syntax
bridge multicast source
{ethernet interface-list | port-channel port-channel-list}]
no bridge multicast source
Parameters
•
ip-address—Specifies the source IP address.
•
ip-multicast-address—Specifies the group IP multicast address.
•
add—Adds ports to the group for the specific source IP address.
•
remove—Removes ports from the group for the specific source IP address.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces; use a hyphen
to designate a range of port channels.
Default Configuration
No multicast addresses are defined.
The default option is add.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
You can execute the command before the VLAN is created.
Example
The following example registers a source IP address - multicast IP address pair to
the bridge table:
Console(config)#
interface vlan
Console(config-if)#
ip-address
group
ip-address
group
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
8
bridge multicast source 239.2.2.2 group 239.2.2.2
ip-multicast-address [[add | remove]
ip-multicast-address
27
331