Cisco Small Business 300 1.1 Series Administration Manual page 75

System Management Commands
78-20269-01 Command Line Interface Reference Guide
The traceroute command terminates when the destination responds, when the
maximum TTL is exceeded, or when the user interrupts the trace with Esc.
The traceroute command is not relevant to IPv6 link local addresses.
Example
Router> traceroute ip umaxp1.physics.lsa.umich.edu
Type Esc to abort.
Tracing the route to umaxp1.physics.lsa.umich.edu (141.211.101.64)
1 i2-gateway.stanford.edu (192.68.191.83)
2 STAN.POS.calren2.NET (171.64.1.213) 0 msec 0 msec 0 msec
3 SUNV--STAN.POS.calren2.net (198.32.249.73) 1 msec 1 msec 1 msec
4 Abilene--QSV.POS.calren2.net (198.32.249.162)
5 kscyng-snvang.abilene.ucaid.edu (198.32.8.103)
6 iplsng-kscyng.abilene.ucaid.edu (198.32.8.80)
7 so-0-2-0x1.aa1.mich.net (192.122.183.9)
8 atm1-0x24.michnet8.mich.net (198.108.23.82)
9 * * *
10 A-ARB3-LSA-NG.c-SEB.umnet.umich.edu(141.211.5.22)58 msec 58msec 58 msec
11 umaxp1.physics.lsa.umich.edu (141.211.101.64)
Trace completed
The following table describes the significant fields shown in the display:
Field
1
i2-gateway.stanford.
edu
192.68.191.83
1 msec 1 msec 1
msec
Description
Indicates the sequence number of the router
in the path to the host.
Host name of this router.
IP address of this router.
Round-trip time for each of the probes that
are sent.
0 msec 0 msec 0 msec
1 msec 1 msec 1 msec
33 msec 35 msec 35 msec
47 msec 45 msec 45 msec
56 msec 53 msec 54 msec
56 msec 56 msec 57 msec
62 msec 63 msec 63 msec
5
76