Table of Contents
Advertisement
Address Table Commands
78-20269-01 Command Line Interface Reference Guide
Parameters
•
ipv6-source-address—Specifies the source IPv6 address.
•
ipv6-multicast-address—Specifies the group IPv6 multicast address.
•
add—Adds ports to the group for the specific source IPv6 address.
•
remove—Removes ports from the group for the specific source IPv6
address.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No multicast addresses are defined.
If ethernet interface-list or port-channel port-channel-list is specified without
specifying add or remove, the default option is add.
You can execute the command before the VLAN is created.
Command Mode
Interface Configuration (VLAN) mode
Example
The following example registers a source IPv6 address - multicast IPv6 address
pair to the bridge table:
Console(config)#
interface vlan
Console(config-if)#
FF00:0:0:0:4:4:4
27.13 bridge multicast ipv6 forbidden source group
Use the bridge multicast ipv6 forbidden source group Interface Configuration
(VLAN) mode command to forbid adding or removing a specific IP source address
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
8
bridge multicast source
2001:0:0:0:4:4:4
group
27
338
Advertisement
Table of Contents
