Table of Contents
Advertisement
Address Table Commands
78-20269-01 Command Line Interface Reference Guide
•
add—Forbids adding ports to the group.
•
remove—Forbids removing ports from the group.
•
interface-list
ethernet
nonconsecutive Ethernet ports with a comma and no spaces. Use a hyphen
to designate a range of ports.
•
port-channel-list
port-channel
nonconsecutive port-channels with a comma and no spaces. Use a hyphen
to designate a range of port channels.
Default Configuration
No forbidden addresses are defined.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
Before defining forbidden ports, the multicast group should be registered.
You can execute the command before the VLAN is created.
Example
The following example registers IP address 239.2.2.2, and forbids the IP address
on port
within VLAN 8.
gi9
Console(config)#
interface vlan
Console(config-if)#
Console(config-if)#
27.7
bridge multicast source group
Use the bridge multicast source group Interface Configuration (VLAN) mode
command to register a source IP address - multicast IP address pair to the bridge
table, and statically add or remove ports to or from the source-group. Use the no
form of this command to unregister the source-group-pair.
—Specifies a list of Ethernet ports. Separate
—Specifies a list of port channels. Separate
8
bridge multicast ip-address
bridge multicast forbidden ip-address
239.2.2.2
239.2.2.2
27
gi9
add
330
Advertisement
Table of Contents
