Cisco Small Business 300 1.1 Series Administration Manual page 116

Configuration and Image File Commands
78-20269-01 Command Line Interface Reference Guide
If the egress interface is not specified, the default interface is selected. The
following combinations are possible:
•
ipv6_address%interface_id - Refers to the IPv6 address on the interface
specified.
•
ipv6_address%0 - Refers to the IPv6 address on the single interface on
which an IPv6 address is defined.
•
ipv6_address - Refers to the IPv6 address on the single interface on which
an IPv6 address is defined.
Understanding Invalid Combinations of Source and Destination
The following are invalid combinations of source and destination files:
•
The source file and destination file are the same file.
•
xmodem: is the destination file. The source file can be copied to image,
boot and null: only.
•
tftp:// is the source file and destination file on the same copy.
•
*.prv files cannot be copied.
•
The destination file cannot be the Running Configuration file.
•
<for products with mirror-config>mirror-config cannot be used as a
destination
The following table describes the characters displayed by the system when copy
is being run:
Character Description
! For network transfers, indicates that the copy process
is taking place. Each exclamation point indicates
successful transfer of ten packets (512 bytes each).
. For network transfers, indicates that the copy process
timed out.
Copying an Image File from a Server to Flash Memory
source-url
Use the copy
server to flash memory. When the administrator copies an image file from the
server to a device, the image file is saved to the "inactive" image. To use this image,
the administrator must switch the inactive image to the active image and reboot.
The device will then use this new image.
flash://image command to copy an image file from a
7
117