Cisco Small Business 300 1.1 Series Administration Manual page 302

Power over Ethernet (PoE) Commands
78-20269-01 Command Line Interface Reference Guide
Port Powered Device
----- --------------
gi1 IP Phone Model A
gi2 Wireless AP Model A
gi3
Example
The following example displays information about the inline power for a specific
port.
console(config)# show power inline
Port Powered Device
----- --------------
gi1 IP Phone Model A
Power limit: 15 W
Power limit (for port power-limit mode): 15 W
The following table describes the fields shown in the display:
Field Description
Power The inline power sourcing equipment
operational status.
Nominal Power The inline power sourcing equipment nominal
power in Watts.
Consumed The measured usage power in Watts.
Power
Usage Threshold The usage threshold expressed in percent for
comparing the measured power and initiating
an alarm if threshold is exceeded.
Traps Indicates if inline power traps are enabled.
Port The Ethernet port number.
Powered device A description of the powered device type.
State Indicates if the port is enabled to provide
power. The possible values are Auto or Never.
State Status
----------- --------
Auto On
Auto On
Auto Off
State Status
----------- --------
Auto On
Priority Class
-------- -------
High Class0
Low Class1
Low N/A
Priority Class
-------- -------
High Class0
23
303