Mitsubishi Electric QD77MS User Manual page 557

(2) The following table shows the items that must be set to use the near-point dog
signal (DOG) as speed-position switching signals.
Setting item
Speed-position
[Cd.45] switching device
selection
(Note): The setting is not required for "[Pr.42] External command function selection" and "[Cd.8] External
command valid".
Refer to Section 5.7 "List of control data" for information on the setting details.
(3) The following table shows the items that must be set to use "[Cd.46] Speed-
position switching command" as speed-position switching signals.
Setting item
Speed-position
[Cd.45] switching device
selection
(Note): The setting is not required for "[Pr.42] External command function selection" and "[Cd.8] External
command valid".
Refer to Section 5.7 "List of control data" for information on the setting details.
Changing the position control movement amount
In "speed-position switching control (INC mode)", the position control movement
amount can be changed during the speed control section.
(1) The position control movement amount can be changed during the speed
control section of speed-position switching control (INC mode).
A movement amount change request will be ignored unless issued during the
speed control section of the speed-position switching control (INC mode).
(2) The "new movement amount" is stored in "[Cd.23] Speed-position switching
control movement amount change register" by the sequence program during
speed control.
When the speed-position switching signal is turned ON, the movement amount
for position control is stored in "[Cd.23] Speed-position switching control
movement amount change register".
(3) The movement amount is stored in the "[Md.29] Speed-position switching
control positioning movement amount" of the axis monitor area from the point
where the control changes to position control by the input of a speed-position
switching signal from an external device.
Setting
Setting details
value
Use the near-point dog signal
1 for switching from speed
control to position control
Setting
Setting details
value
Use the "[Cd.46] Speed-
position switching command"
2
for switching from speed
control to position control
9 - 99
Chapter 9 Major Positioning Control
Buffer memory address
QD77MS2
QD77MS4
1566+100n
Buffer memory address
QD77MS2
QD77MS4
1566+100n
QD77MS16
4366+100n
QD77MS16
4366+100n