Mitsubishi Electric QD77MS User Manual page 927

Related buffer memory address
QD77MS2
QD77MS16
QD77MS4
67
68+150n
69+150n
30100+200n 28400+100n
70+150n
71+150n
72+150n
73+150n
74+150n
75+150n
Set range
(Setting with sequence program)
0, 1
<Torque initial value selection (b4 to b7)>
0, 1
<Speed initial value selection (b8 to b11)>
0, 1, 2
<Condition selection at mode switching
(b12 to b15)>
0, 1
0, 1, 2, 3, 4
32
0, 4, 5, 6, 7, 8
0, 1
• [mm] [inch] [PLS]
–2147483648 to 2147483647
• [degree] 0 to 35999999
<OPR speed>
1 to 1000000000 [PLS/s]
-2
1 to 2000000000 [ 10 mm/min or others]
16 - 47
Chapter 16 Troubleshooting
Remedy
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON.
With the setting brought into the setting range, switch the
power on again or reset the PLC.
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON.
• Bring the setting into the setting range.
• Set the speed to the bias speed at start or higher.
(Refer to Section 5.2.5)
n: Axis No.-1