Mitsubishi Electric QD77MS User Manual page 921

Related buffer memory address
QD77MS2
QD77MS16
QD77MS4
22+150n
23+150n
24+150n
25+150n
26+150n
27+150n
28+150n
29+150n
30+150n
33
34+150n
32+150n
35
31+150n
Set range
(Setting with sequence program)
0, 1
0, 1
1 to 2147483647
1 to 1000
0, 1
0, 1
0, 1
0, 1, 2
0, 1, 2, 3
0, 2
0, 1, 2, 3, 4, 5, 6
0, 1
0, 1
16 - 41
Chapter 16 Troubleshooting
Remedy
• Bring the setting into the setting range.
• In the unit of "degree", set "0: Apply software stroke limit on
current feed value".
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON.
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON.
• Speed-position switching control (ABS mode) should satisfy
the conditions 1) to 3) given on the left.
• When speed-position switching control (ABS mode) is not to
be exercised, set 0 to speed-position function selection and
turn the PLC READY signal [Y0] from OFF to ON.
With the setting brought into the setting range, turn the PLC
READY signal [Y0] from OFF to ON.
With the setting of the axis is matched, turn the PLC READY
signal [Y0] from OFF to ON.
n: Axis No.-1