Mitsubishi Electric QD77MS User Manual page 282

Storage item
[Md.46] Last executed positioning
data No.
[Md.47] Positioning data being
executed
[Md.48] Deceleration start flag

This area stores the positioning data No. attached to the positioning data that was
executed last time.

The value is retained until a new positioning operation is executed.

This area stores "0" when the JOG/inching operation is executed.
Refresh cycle: Immediate

The addresses shown to the right store details of the positioning data currently
being executed (positioning data No. given by [Md.44]).
Refresh cycle: Immediate

"1" is stored when the constant speed status or acceleration status switches to
the deceleration status during position control whose operation pattern is
"Positioning complete".

"0" is stored at the next operation start or manual pulse generator operation
enable.
Refresh cycle: Immediate
[POINT]
This parameter is possible to monitor when "[Cd.41] Deceleration start flag valid"
is valid.
5 - 144
Chapter 5 Data Used for Positioning Control
Storage details