Mitsubishi Electric QD77MS User Manual page 84

Common functions
Optional data monitor function
Module error collection function
Connect/disconnect function of SSCNET
communication
QD75MH initial value setting function
Hot line forced stop function
This function is used to store the data selected by user up to 4
data per axis to buffer memory and monitor them.
This function collects errors occurred in the Simple Motion
module in the PLC CPU.
Holding the error contents in the PLC CPU, this function enables
to check the error history even after the PLC CPU in powered off
or reset.
Temporarily connect/disconnect of SSCNET communication is
executed during system's power supply ON.
This function is used to exchange the servo amplifiers or
SSCNET cables.
This function is used to set the factory-set initial value of
QD75MH for the setting data set in the QD77MS buffer
memory/internal memory and flash ROM/internal memory
(nonvolatile).
This function is used to execute deceleration stop safety for
other axes when the servo alarm occurs in the servo amplifier
MR-JE-B.
3 - 12
Chapter 3 Specifications and Functions
Details
Reference
section
14.11
14.12
14.13
14.14
14.15