Mitsubishi Electric QD77MS User Manual page 874

[Functions]
Sequence program
ZP.PFWRT instruction
Complete device
Complete state display
device
[Errors]
(1) The ZP.PFWRT instruction completion can be confirmed using the complete
devices ((D)+0) and ((D)+1).
(a) Complete device ((D)+0)
This device is turned ON by the END processing of the scan for which
ZP.PFWRT instruction is completed, and turned OFF by the next END
processing.
(b) Complete state display device ((D)+1)
This device is turned ON and OFF according to the state in which ZP.PFWRT
instruction is completed.
• When completed normally
• When completed abnormally : This device is turned ON by the END
END END
processing processing
ON
OFF
OFF
OFF
(1) When a dedicated instruction is completed abnormally, the error complete signal
((D)+1) is turned ON, and the error code is stored in the complete status ((S)+1).
Check and take measures against the error referring to Section 16.4 "List of errors".
: Kept unchanged at OFF.
processing of the scan for which ZP.PFWRT
instruction is completed, and turned OFF by
the next END processing. (Same ON/OFF
operation as the complete device.)
ZP.PFWRT instruction
execution completion
15- 12
Chapter 15 Dedicated Instructions
END
processing processing
ON
When
completed
ON
abnormally
When
completed normally
1 scan
END