Mitsubishi Electric QD77MS User Manual page 854

[3] Buffer memory list
Setting item
SSCNET control
[Cd.102]
command
(5) Execute the connect/disconnect command to the A-axis for multiple-axis
servo amplifier.
(6) When using the driver communication function, it can be disconnected by
executing the connect/disconnect command, however it cannot be connected
again.
(7) The connect/disconnect/execute command cannot be accepted during
amplifier-less operation mode. "[Md.53] SSCNET control status" will be "0:
Command accept waiting" (The disconnection is released.).
If being switched to the amplifier-less operation mode when "[Md.53]
SSCNET control status" is "1: Disconnected axis existing", the disconnected
axis is automatically connected when switching to the normal operation mode
again.
If being switched to the amplifier-less operation mode when "[Md.53]
SSCNET control status" is "-1: Execute waiting", the connect/disconnect
command becomes invalid.
The buffer memory for the connect/disconnect function of SSCNET
communication is shown below.
(1) System control data
Setting
value
The connect/disconnect command of SSCNET
communication is executed.
0
(Note-1)
Axis No.
-2
-10
Except above setting: Invalid
(Note-1): QD77MS2 : 1 to 2,
QD77MS4 : 1 to 4,
QD77MS16: 1 to 16
Setting details
: No command
: Disconnect command of
SSCNET communication
(Axis No. to be
disconnected)
: Execute command
: Connect command of
SSCNET communication
14 - 58
Chapter 14 Common Functions
Buffer memory address
QD77MS2
QD77MS16
QD77MS4
1932 5932