Appendix 6.5 Connection With Mr-Je-B - Mitsubishi Electric QD77MS User Manual

Appendix 6.5 Connection with MR-JE-B

The servo amplifier MR-JE-B can be connected using SSCNET /H.
The details shown below explain about the "Connection with MR-JE-B".
[1] Comparisons of specifications with MR-J4(W)-B
[1] Comparisons of specifications with MR-J4(W)-B
Item
[Pr.100] Servo series
Operation mode
Detailed [Pr.80] External input
parameter 1 signal selection
Control loop (semi/fully) switching
command
Encoder resolution
Amplifier-less operation function
Driver communication
Virtual servo amplifier function
(Note-1): When the software version of the servo amplifier is "C4" or before:
When "1: External input signal of servo amplifier" is set in "[Pr.80] External input signal selection"
at MR-JE-B use, the axis error or warning does not occur and the external signal (upper/lower
limit switch, near-point dog) cannot be operated. Refer to Section 14.4 "External signal selection
function" for the program example and system configuration when "2: Buffer memory of
QD77MS" is set.
(Note-2): Operates artificially as the following servo amplifier and servo motor during amplifier-less
operation mode.
Servo amplifier type: MR-J4-10B
Motor type: HG-KR053 (Resolution per servo motor rotation: 4194304 pulses)
Important
The servo amplifier MR-JE-B is integrated with the main circuit power supply and
the control power supply.
Therefore, when the power of the servo amplifier is turned OFF, the controller
cannot communicate with the axes after the axis whose power is turned OFF.
MR-JE-B
48: MR-JE-_B
Standard
External input signals of
servo amplifier are not
(Note-1)
available.
Invalid
131072 pulses/rev
(Note-2)
Possible
Not possible
Not possible
Appendix - 99
Appendices
MR- J4(W)-B
32: MR-J4-_B_(-RJ), MR-J4W_-_B
(2-, 3- axis type)
Standard/Fully closed/Linear/Direct
drive
External input signals of servo
amplifier are available.
Valid when using servo amplifier for
fully closed loop control
4194304 pulses/rev
Possible
Possible
Possible