Control Unit; Communication With The Simple Motion Module - Mitsubishi Electric QD77MS User Manual

(4) System configuration
Unless particularly designated, the sequence program for the following system
using QD77MS4 is shown in this chapter and subsequent.
Refer to Section 6.2 for the application of the devices to be used.

(5) Control unit

In the program, the unit of "0: mm, 2: degree" is set for the basic parameter 1.

(6) Communication with the Simple Motion module

There are two methods for communication with the Simple Motion module using
the sequence program: a method using an "intelligent function device" and a
method using a FROM/TO command.
In the sequence program in this chapter and subsequent, the program example
using the "intelligent function device" is shown without using a FROM/TO
command for communication with the Simple Motion module.
When using the FROM/TO command for communication with the Simple Motion
module, change the circuit incorporating the "intelligent function device" as
follows.
(a) When the circuit uses the "intelligent function device" on the destination (D)
side of a MOV command, change the command to a TO command.
X21
0
X21
0
Chapter 6 Sequence Program Used for Positioning Control
Q Q
P Q
L D X X
C 77 41 40
C M
P S
U 4
X20 X40
00
to to
to
X3F X4F
1F
X40 to X4F
X20 to X3F
Servo
amplifier
Servomotor
M
6 - 3
Q35B
External
devices
Intelligent function device
MOVP K1
TOP H0 K1505 K1
Designated Designated
value value
at U0 at G1505
U0\
G1505
K1
Number of
write data (1)