Mitsubishi A1SD75M3 User Manual page 74

4 INSTALLATION, WIRING AND MAINTENANCE OF THE PRODUCT
No. Name
1) 17-segment LED
2) Axis display LED (AX1 to 3)
3) Mode switch
4) Module version label
Peripheral device connection
5)
connector
External device connection
6)
connector
SSCNET connection
7)
connector
AD75M1
RS-422
AX1
Display the operating status (1)) of the target axis (2)) for that axis.
RUN : The LED corresponding to the operating axis flickers.
TEST : The LEDs of all axes turn ON.
IDL : OFF
ERR : The LED corresponding to the axis in error flickers.
Each time this switch is pressed, the details displayed on "1) 17-segment LED" and
"2) Axis display LED" will change.
[Display details]
Operation monitor 1
Input information n
(Refer to section "13.4 LED display function" for details on the displayed
information.)
This label indicates the module's software version and hardware version.
(Example)
A B
Connector for connecting with peripheral device.
Connector for connecting mechanical system input and manual pulse generator.
SSCNET connector for connection with the servo amplifier.
Each AD75 interface is as shown below.
AD75M2
RS-422
AX1
AX2
Details
Operation monitor 2
Internal information 1
Internal information 2
Indicates that software version is "B".
Indicates that hardware version is "A".
AD75M3 A1SD75M1
AX1
MODE
RS-422
RS-422
AX1
AX3 AX2
A1SD75M1
4 - 4
MELSEC-A
A1SD75M2 A1SD75M3
AX1 AX1
MODE
RS-422
AX2 AX2
A1SD75M2 A1SD75M3
MODE
RS-422
AX3