Mitsubishi A1SD75M3 User Manual page 265

5 DATA USED FOR POSITIONING CONTROL
Set with a decimal.
Setting value
K
Set with a decimal.
Setting value
K
After the axis error reset is completed, "0" is stored by the OS.
(Indicates that the axis error reset is completed.)
Set with a decimal.
Setting value
K
After restart acceptance is completed, "0" is stored by the OS.
(Indicates that the restart acceptance is completed.)
Set with a decimal.
Setting value
K
After the M code ON signal turns OFF, "0" is stored by the OS.
(Indicates that the OFF request is completed.)
Setting value
Positioning data No.
· 1 to 600 : Positioning data No.
· 7000 to 7010 : Block start designation
: Indirectly specification
· 8001 to 8050
· 9001 : Machine zero point return
· 9002 : High-speed zero point return
: Current value change
· 9003
1
Error reset request
Axis 1: Axis error is reset.
(Set by sequence program)
1
Restart command
1: Restarts
(Set by sequence program)
1
M code OFF request
1: M code ON signal turns OFF
(Set by sequence program)
5 - 175
MELSEC-A
Storage buffer
memory address
Default value
Axis 1 Axis 2 Axis 3
0 1150 1200
0 1151 1201
0 1152 1202
0 1153 1203
1250
1251
1252
1253