Mitsubishi A1SD75M3 User Manual page 585

13 COMMON FUNCTIONS
(b) "Operation monitor 2" display details
The axis operation status is displayed in the "operation monitor 2" mode.
The status display of each axis changes over every 0.5 seconds.
< Display >
IDLE ............. Standing by
STOP ........... Stopped
JOG.............. In JOG operation
MANP .......... In manual pulse generator operation
OPR ............. In zero point return
POSI ............ In position control
VELO ........... In speed control
V- P .............. In speed control of speed/position changeover control
V -P .............. In position control of speed/position changeover control
BUSY ........... Waiting for conditions, etc.
E ......... When an error occurs
Error No. display
When an error occurs in an axis, that error No. is displayed for 0.5
seconds before the display changes over to the next axis.
(c) "Input information n" display details
The status of each signal is displayed in the "input information n" mode.
The displayed signal is changed over in the following order every time the
"mode switch" is pressed.
The "axis display LED" is lit when the displayed signal is ON.
< Display >
SVON........... Servo ON signal
ULMT ........... Upper limit signal
LLMT............ Lower limit signal
V-P ............... Speed/position changeover signal
DOG............. Near-point dog signal
(d) Other display details
The following details are displayed in the 17-segment LED as error
messages, regardless of the mode.
< Display >
FALT ............ This error message may be displayed if any of the
< Details >
< Details >
< Details >
parameter values saved in the flash ROM becomes
illegal. In this case, perform operation in the following
procedure. This error is due to a hardware fault if "FALT"
is still displayed after the operation has been performed in
the following procedure or if "FALT" is displayed in Step
3) of the following procedure.
13 - 9
MELSEC-A