Mitsubishi A1SD75M3 User Manual page 224

5 DATA USED FOR POSITIONING CONTROL
Da.14 Condition target
01 : Device X
H
02 : Device Y
H
03 : Buffer memory (1-word)
H
04 : Buffer memory (2-word)
H
05 : Positioning data No.
H
Da.14 Condition target
01 : Device X
H
02 : Device Y
H
03 : Buffer memory (1-word)
H
04 : Buffer memory (2-word)
H
05 : Positioning data No.
H
Da.14 Condition target
Set the condition target as required for each control.
Setting value
01 : Device X
H
02 : Device Y
H
03 : Buffer memory (1-word)
H
04 : Buffer memory (2-word)
H
05 : Positioning data No.
H
Da.15 Condition operator
Set the condition operator as required for the " Da.14 Condition target".
Setting value
07 : DEV=ON
H
08 : DEV=OFF
H
: ∗∗=P1
01
H
: ∗∗≤P1, P2≤∗∗
06
H
09 : Axis 1 designation
H
0E : Axis 2 and axis 3
H
designation
Da.16 Address
Set the address as required for the " Da.14 Condition target".
Setting value
Value
(Buffer memory address)
Set the input/output signal ON/OFF as the conditions.
Set the value stored in the buffer memory as the condition.
03 : The target buffer memory is "1-word (16 bits)"
H
04 : The target buffer memory is "2-word (32 bits)"
H
Select only for "simultaneous start".
When the input/output signal ON/OFF is set as the
condition, set "ON" or "OFF".
Set how to judge the conditions for the value (∗∗)
target stored in the buffer memory.
Set the axis to start simultaneously when
"simultaneous start" is selected.
– Not used. (There is no need to set.)
Set the target "buffer memory address".
(For 2 word, set the low-order buffer memory
address.)
– Not used. (There is no need to set.)
5 - 134
MELSEC-A
Setting details
Setting details
Setting details