Toshiba e-STUDIO206L Service Manual page 1289

Sub
05/08 Mode Element
element
05 Adjustmen Process Developer Automatic adjustment
t mode of auto-toner sensor
05 Adjustmen Process Developer Correction of auto-
t mode toner sensor
05 Adjustmen Process Developer
t mode
05 Adjustmen Process Charger
t mode
05 Adjustmen Process Transfer
t mode
05 Adjustmen Process Separation
t mode
e-STUDIO207L/257/307/357/457/507
Item Subitem Code
2000
2001
2020
2040
2052
2078
Sub- Default Acceptable
Details
code value value
Fuser heater ON -
Fuser heater ON 141 0~255
Developer bias DC 149 0~255
output adjustment
Main charger grid bias Refer to 0~255
output adjustment contents
Transfer transformer Refer to 0~255
DC output adjustment contents
(C)
Separation 52 0~255
transformer DC
output adjustment (C)
1
RAM Contents
- As the value increases, the sensor output increases
correspondingly. The value starts changing approx. 2
minutes after this adjustment was started and is
automatically set in the range of 2.35 to 2.45 V.
* Selection is disable when developer unit is not
installed.
M Corrects the control value of the auto-toner sensor
setup in 05-2000.
* Selection is disable when developer unit is not
installed.
M As the value increases, the transformer output
increases correspondingly. Remove the developer unit
and install the adjustment jig to make adjustment.
M As the value increases, the transformer output
increases correspondingly. Remove the developer unit
and install the adjustment jig to make adjustment.
<Default value>
e-STUDIO207L/257/307: 105
e-STUDIO357/457/507: 107
M As the value increases, the transformer output
increases correspondingly. Remove the developer unit
and install the adjustment jig to make adjustment.
<Default value>
e-STUDIO207L/257/307: 88
e-STUDIO357/457/507: 117
M As the value increases, the transformer output
increases correspondingly. Remove the developer unit
and install the adjustment jig to make adjustment.
Proc Service
edure UI
17 Yes
3 Yes
3
3
3
3