Toshiba e-STUDIO206L Service Manual page 1291

Sub
05/08 Mode Element
element
05 Adjustmen Process Image
t mode quality
control
05 Adjustmen Process Process
t mode
05 Adjustmen Process Toner
t mode recycle
05 Adjustmen Scanner Scanner
t mode
05 Adjustmen Scanner Scanner Image location
t mode adjustment
05 Adjustmen Scanner Scanner Image location
t mode adjustment
05 Adjustmen Scanner Scanner Reproduction ratio
t mode adjustment
05 Adjustmen Scanner Scanner Distortion mode
t mode
05 Adjustmen Scanner Scanner Shading position
t mode adjustment
05 Adjustmen Scanner Scanner Shading position
t mode adjustment
05 Adjustmen Scanner RADF Adjustment of RADF
t mode paper alignment
05 Adjustmen Scanner RADF Adjustment of RADF
t mode paper alignment
e-STUDIO207L/257/307/357/457/507
Item Subitem Code
2250
2382
2390
3009
3030
3031
3032
3033
3034
3035
3040
3041
Sub- Default Acceptable
Details
code value value
Laser power Refer to 0~255
adjustment contents
Reverse time of the Refer to 0~255
drum contents
Forced performing of -
idling
Log table switching 2 0~4
for RADF copying
(color)
Primary scanning 115 0~255
direction (scan.
section)
Secondary scanning 124 90~166
direction(scan.section
)
Adj. secondary 117 63~193
scan.direction
Distortion mode -
Original glass 117 92~165
RADF 133 92~165
Front side 12 0~30
Back side 12 0~30
3
RAM Contents
M When the value increases, the laser output increases
correspondingly.
<Default value>
e-STUDIO207L/257/307: 73
e-STUDIO357/457/507: 124
M <Default value>
e-STUDIO207L/257/307: 12
e-STUDIO357/457/507: 10
M Perform this adjustment before the replacement of the
developer material. (The toner is forcibly removed from
the cleaner.)
SYS 0: Same log table as the one used at copying with
original glass
1: Background reproduction - Light 2
2: Background reproduction - Light 1
3: Background reproduction - Dark 1
4: Background reproduction - Dark 2
SYS When the value increases by "1", the image shifts by
approx. 0.04233 mm toward the front side of the paper.
SYS When the value increases by "1", the image shifts by
approx. 0.13013 mm toward the trailing edge of the
paper.
SYS When the value increases by "1", the reproduction ratio
in the secondary scanning direction (vertical to paper
feeding direction) increases by approx. 0.025 %.
- Moves carriages to the adjusting position.
SYS 0.13013 mm/step
SYS 0.13013 mm/step
SYS When the value increases by "1", the aligning amount
increases by approx. 0.5 mm.
SYS When the value increases by "1", the aligning amount
increases by approx. 0.5 mm.
Proc Service
edure UI
3 Yes
1
6 Yes
1
1 Yes
1 Yes
1 Yes
6 Yes
1
1
1 Yes
1 Yes