Toshiba e-STUDIO206L Service Manual page 1366

Sub
05/08 Mode Element
element
08 Setting Scanner
Mode
08 Setting Scanner
Mode
08 Setting Scanner RADF
Mode
08 Setting Scanner
Mode
08 Setting System User Card reader
Mode interface
e-STUDIO207L/257/307/357/457/507
Item Subitem Code
3025
3065
3075
3080
3500
Sub- Default Acceptable
Details
code value value
Correction of carriage 2
position
Initialization of model -
information in lens
unit
Allowing of trailing 0
edge adjustment of
scanning
Detection method of 1 1, 3
original size
Device setting 0
429496729
23
RAM Contents
0-2 SYS 0: No correction
1: Performs correction before scanning
2: Performs correction after scanning
- - Normally this code is not used. When an error occurs
by installing the lens unit used for other models,
perform this code to initialize the model information.
0-1 SYS 0: Not allowed
1: Allowed
SYS 1: Two-step detection (lights twice)
3: Single-step detection (lights once)
When "3" is set, the detection accuracy of dark
originals may decrease.
0- SYS To enable the e-Bridge ID Gate, a card reading device
should be set in the order of "ABYYZZZZ". (Enter the
5 corresponding values to "A", "B", "YY" and "ZZZZ".)
- AB: Special setting
- A: Debugging NIC
0: Not used 1: Used
- B: Interface
0: USB connection 1: Serial connection (KP-2003
only)
- YY: Authentication
00: No authentication using card
03: Mifare (KP-2005 only)
04: HID (KP-2004 only)
06: KB Emulation I/F Reader
07: 3Track Magnetic Swipe Reader
09: 2Track Magnetic Swipe Reader
- ZZZZ: Sub-code (Specifies the usage type of card ID)
0000: No authentication using card
0001: IDm (Felica/NFC-Felica) and (or) UID
(Mifare/NFC-Mifare)
0002: Data (Felica/NFC-Felica/Mifare/NFC-Mifare)
0003: SSFC mode
Proc Service
edure UI
1
3
1
1
5 Yes