Toshiba e-STUDIO206L Service Manual page 1293

Sub
05/08 Mode Element
element
05 Adjustmen Scanner Scanner Size detection of
t mode original
05 Adjustmen Scanner Scanner Size detection of
t mode original
05 Adjustmen Scanner Scanner Size detection of
t mode original
05 Adjustmen Scanner Scanner Size detection of
t mode original
05 Adjustmen Scanner RADF
t mode
05 Adjustmen Printer Printer Fine adjustment of
t mode polygonal motor
rotation speed
05 Adjustmen Printer Printer Fine adjustment of
t mode polygonal motor
rotation speed
05 Adjustmen Printer Image Adjustment of primary
t mode scanning laser writing
start position.
e-STUDIO207L/257/307/357/457/507
Item Subitem Code
3233
3234
3236
3237
3350
Adjustment of primary 4000
scanning direction
reproduction ratio
Adjustment of primary 4001
scanning direction
reproduction ratio
4005
Sub- Default Acceptable
Details
code value value
Position adjustment in Refer to 0-255
the primary scanning contents
direction
Waiting position 200 0-255
adjustment of
carriage
Adjustment of lamp 128 0-255
lighting time
Starting time 64 0-255
adjustment of lamp
lighting
Trailing edge 50 0-100
adjustment of
scanning
PPC 128 0~255
PRT 133 0~255
PPC Refer to 0~255
contents
5
RAM Contents
SYS Adjusts the detection range for size of original.
<Default value>
NAD/TWD/CND: 128
Others: 58
SYS Adjusts the position where the carriage stops at the
size detection of the original.
Default value: 200 (20 mm from leading edge of
original)
Maximum value: 255 (25.5 mm from leading edge of
original)
Minimum value: 0 (0 mm from leading edge of original)
SYS Adjusts the lighting time of the lamp at the size
detection of the original.
Maximum value: 255 (Minimum time + 2040ms)
Minimum value: 0 (Minimum time)
SYS Adjusts the starting time of lamp lighting when the
detection accuracy of dark originals is poor.
Maximum value: 255 (Minimum time + 2040 ms)
Minimum value: 0 (Minimum time)
SYS When the value increases by "1", the trailing edge of
scanned original becomes longer by 0.3 mm at RADF
copying.
When the value decreases by "1", the trailing edge of
scanned original becomes shorter by 0.3 mm at RADF
copying.
* This code is effective when the value of 08-3075 is "1"
(Allowed).
M When the value increases by "1", the reproduction ratio
of primary scanning direction increases by approx.
0.07%. (approx. 0.1 mm/step)
M When the value increases by "1", the reproduction ratio
of primary scanning direction increases by approx.
0.07%. (approx. 0.1 mm/step)
M When the value increases by "1", the writing start
position shifts to the front side by approx. 0.0423 mm.
<Default value>
e-STUDIO207L/257/307: 88
e-STUDIO357/457/507: 99
Proc Service
edure UI
1
1
1
1
1
1 Yes
1 Yes
1 Yes