Analog Comparator Control 3 Register (Acompctrl3); Analog Comparator Control 3 Register (Acompctrl3) Register Field Descriptions - Texas Instruments UCD3138 Technical Reference Manual

www.ti.com

6.11.4 Analog Comparator Control 3 Register (ACOMPCTRL3)

Address 0003000C
Figure 6-8. Analog Comparator Control 3 Register (ACOMPCTRL3)
14
7 6
Reserved
R-00
LEGEND: R/W = Read/Write; R = Read only; -n = value after reset
Table 6-4. Analog Comparator Control 3 Register (ACOMPCTRL3) Register Field Descriptions
Bit Field
14-8 ACOMP_G_
THRESH
7-6 Reserved
5-3 ACOMP_G_SEL
2 ACOMP_G_
POL
1 ACOMP_G_INT_
EN
0 ACOMP_G_OUT_
EN
SNIU028A – February 2016 – Revised April 2016
Submit Documentation Feedback
ACOMP_G_THRESH
R/W-000 0000
5
ACOMP_G_SEL
R/W-000
Type Reset
R/W 000 0000 Configures Analog Comparator G Threshold
0 = Comparator Reference of 19.53125 mV (Default)
1 = Comparator Reference of 39.0625 mV
........
127 = Comparator Reference of 2.5 V
R 00
R/W 000
Configures Analog Comparator G Threshold
0 = Analog Comparator G Threshold set by ACOMP_G_THRESH (Default)
1 = Analog Comparator G Threshold set by Comparator Ramp 0
2 = Analog Comparator G Threshold set by Filter 0 Output
3 = Analog Comparator G Threshold set by Filter 1 Output
4 = Analog Comparator G Threshold set by Filter 2 Output
R/W 1
Analog Comparator G Polarity
0 = Comparator result enabled when input falls below threshold
1 = Comparator result enabled when input exceeds threshold (Default)
R/W 0
Analog Comparator G Interrupt Enable
0 = Disables Analog Comparator G Interrupt generation (Default)
1 = Enables Analog Comparator G Interrupt generation
R/W 0
Analog Comparator G DAC Output Enable
0 = Disables output of Comparator DAC G onto AD pin (Default)
1 = Enables output of Comparator DAC G onto AD pin
Copyright © 2016, Texas Instruments Incorporated
Fault Mux Registers Reference
3 2
ACOMP_G ACOMP_G
_POL
R/W-1
Description
8
1 0
ACOMP_G
_INT_EN _OUT_EN
R/W-0 R/W-0
241
Fault Mux