Texas Instruments UCD3138 Technical Reference Manual page 240

Fault Mux Registers Reference
Table 6-3. Analog Comparator Control 2 Register (ACOMPCTRL2) Register Field Descriptions (continued)
Bit Field
5-3 ACOMP_E_SEL
2 ACOMP_E_POL
1 ACOMP_E_INT
_EN
0 ACOMP_E_OUT_
EN
240
Fault Mux
Type Reset
R/W 000
Configures Analog Comparator E Threshold
0 = Analog Comparator E Threshold set by ACOMP_E_THRESH (Default)
1 = Analog Comparator E Threshold set by Comparator Ramp 0
2 = Analog Comparator E Threshold set by Filter 0 Output
3 = Analog Comparator E Threshold set by Filter 1 Output
4 = Analog Comparator E Threshold set by Filter 2 Output
R/W 1
Analog Comparator E Polarity
0 = Comparator result enabled when input falls below threshold
1 = Comparator result enabled when input exceeds threshold (Default)
R/W 0
Analog Comparator E Interrupt Enable
0 = Disables Analog Comparator E Interrupt generation (Default)
1 = Enables Analog Comparator E Interrupt generation
R/W 0
Analog Comparator E DAC Output Enable
0 = Disables output of Comparator DAC E onto AD pin (Default)
1 = Enables output of Comparator DAC E onto AD pin
Copyright © 2016, Texas Instruments Incorporated
Description
SNIU028A – February 2016 – Revised April 2016
Submit Documentation Feedback
www.ti.com