Huawei Quidway S3900 series Command Manual page 512

Command Manual – 802.1x
Quidway S3900 Series Ethernet Switches-Release 1510
Authentication Mode is Auto
Port Control Type is Mac-based
Max number of on-line users is 256
Authentication Success: 0, Failed: 0
EAPOL Packets: Tx 0, Rx 0
Sent EAP Request/Identity Packets : 0
Received EAPOL Start Packets : 0
Controlled User(s) amount to 0
Ethernet1/0/3
......
Table 1-1 Description on the fields of the display dot1x command
Equipment 802.1X protocol is
enabled
CHAP authentication is enabled CHAP authentication is enabled.
DHCP-launch is disabled
Proxy trap checker is disabled
Proxy logoff checker is disabled
Transmit Period
EAP Request/Challenge Packets: 0
EAPOL LogOff Packets: 0
EAP Response/Identity Packets : 0
EAP Response/Challenge Packets: 0
Error Packets: 0
Field
Huawei Technologies Proprietary
Chapter 1 802.1x Configuration Commands
Description
802.1x protocol (802.1x for short) is enabled on
the switch.
DHCP-triggered.802.1x authentication is disabled.
Whether to check a supplicant system that logs in
through a proxy:
Disable means the switch does not send Trap
packets when it detects that a supplicant
system logs in through a proxy.
Enable means the switch sends Trap packets
when it detects that a supplicant system logs in
through a proxy.
Whether to check a supplicant system that logs in
through a proxy:
Disable means the switch does not disconnect
a supplicant system when it detects that the
latter logs in through a proxy.
Enable means the switch disconnects a
supplicant system when it detects that the latter
logs in through a proxy.
Setting of the Transmission period timer (the
tx-period)
1-3