Peer - Huawei Quidway S3900 series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
View
RIP view
Parameter
network-address: Address of the network for which RIP is enabled/disabled. It can be
the IP network address of any interface.
Description
Use the network command to enable RIP on a specified interface.
Use the undo network command to disable RIP on the interface.
By default, RIP is disabled on any interface.
After a RIP routing process is started, it is disabled on any interface. To enable RIP
routing on an interface, you must use the network command.
The undo network command is similar to the undo rip work command in function. But
they are not identical.
Their similarity is that the interface using either command will not receive/transmit RIP
routes any more.
The difference between them is that, in the case of undo rip work, other interfaces will
still forward the routes of the interface on which the undo rip work command is
executed. In the case of undo network, other interfaces will not forward the routes of
the interface on which the undo network command is executed and it seems that the
interface disappeared.
When the network command is used on an address, the effect is that the interface on
the network segment at this address is enabled. For example, the results of viewing the
network 129.102.1.1 with both the display current-configuration command and the
display rip command are shown as network 129.102.0.0.
Related command: rip work.
Example
# Enable RIP on the interface with the network address 129.102.0.0.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] rip
[Quidway-rip] network 129.102.0.0

2.1.11 peer

Syntax
peer ip-address
Huawei Technologies Proprietary
2-10
Chapter 2 RIP Configuration Commands