Display Ip Routing-Table Protocol - Huawei Quidway S3900 series Command Manual

Command Manual - Management VLAN
Quidway S3900 Series Ethernet Switches-Release 1510
Summary count: 2
**Destination: 10.1.1.0
**Destination: 10.1.1.2
Refer to Table 1-5 for the description on the output fields.

1.1.10 display ip routing-table protocol

Syntax
display ip routing-table protocol protocol [ inactive | verbose ]
View
Any view
Parameter
protocol: This argument can be one of the following:
direct: Displays the information about the direct routes.
ospf: Displays the information about OSPF routes.
ospf-ase: Displays the information about ASE routes.
ospf-nssa: Displays the information about NSSA routes.
rip: Displays the information about RIP routes.
static: Displays the information about the static routes.
inactive: Displays the information about the inactive routes. If you do not specify this
keyword, the information about both active and inactive routes is displayed.
verbose: Displays the detailed route information. If you do not specify this keyword,
only the summary route information is displayed.
Description
Use the display ip routing-table protocol command to display the information about
specific routes.
Protocol: #DIRECT
*NextHop: 10.1.1.2
Vlinkindex: 0
State: <Int ActiveU Retain Unicast>
Age: 3:23:44 Cost: 0/0
Protocol: #DIRECT
*NextHop: 127.0.0.1
Vlinkindex: 0
State: <NoAdvise Int ActiveU Retain Gateway Unicast>
Age: 3:23:44 Cost: 0/0
Huawei Technologies Proprietary
Chapter 1 Management VLAN Configuration
Mask: 255.255.255.0
Preference: 0
Interface: 10.1.1.2(Vlan-interface1)
Tag: 0
Mask: 255.255.255.255
Preference: 0
Interface: 127.0.0.1(InLoopBack0)
Tag: 0
1-14
Commands