Huawei Quidway S3900 series Command Manual page 165

Command Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510
Output(normal): - packets, - bytes
Output: 0 output errors,
Table 1-2 Description on the fields of the display interface command
Ethernet1/0/1 current state
IP Sending Frames' Format
Hardware address
Media type
Port hardware type
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex
type is force link
Flow-control is enabled
The Maximum Frame Length
Broadcast MAX-ratio
Unicast MAX-ratio
Multicast MAX-ratio
Allow jumbo frame to pass
PVID
Mdi type
Port link-type
Tagged VLAN ID
Untagged VLAN ID
Last 300 seconds input: 0 packets/sec 0
bytes/sec
Last 300 seconds output: 0 packets/sec 0
bytes/sec
- broadcasts, - multicasts, - pauses
- underruns, - buffer failures
0 aborts, 0 deferred, 0 collisions, 0 late collisions
0 lost carrier, - no carrier
Field
Huawei Technologies Proprietary
Chapter 1 Port Basic Configuration
Current Ethernet port status: up or
down
Ethernet frame format
Port hardware address
Media type
Port hardware type
Current speed mode and duplex mode
Link speed and duplex status ( force or
auto-negotiation)
Status of flow-control on the port
Maximum frame length allowed on the
port
Broadcast suppression ratio on the
port
Unknown unicast suppression ratio on
the port
Multicast suppression ratio on the port
Whether Jumbo frame is allowed on
the port.
Default VLAN ID of the port
Network cable type
Port link type
Identify the VLANs whose packets will
be forwarded with tags on the port.
Identify the VLANs whose packets will
be forwarded without tags on the port.
Rate and number of incoming and
outgoing packets in the last 300
seconds
1-8
Commands
Description