Display Ip Routing-Table Protocol - Huawei Quidway S3900 series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510

1.1.6 display ip routing-table protocol

Syntax
display ip routing-table protocol protocol [ inactive | verbose ]
View
Any view
Parameter
protocol: You can provide one of the following values for this argument.
direct: Displays direct-connect route information
static: Displays static route information.
ospf: Displays OSPF route information.
ospf-ase: Displays OSPF ASE route information.
ospf-nssa: Displays OSPF NSSA route information.
rip: Displays RIP route information.
inactive: With this argument provided, this command displays the inactive route
information. Without this argument provided, this command displays both active and
inactive route information.
verbose: With this argument provided, this command displays the verbose route
information. Without this argument provided, this command displays route summary
only.
Description
Use the display ip routing-table protocol command to display the route information
of a specific protocol.
Example
# Display the summary of all direct-connect routes.
<Quidway> display ip routing-table protocol direct
DIRECT Routing tables:
Summary count: 4
DIRECT Routing tables status:<active>:
Summary count: 3
Destination/Mask
20.1.1.1/32
127.0.0.0/8
127.0.0.1/32
DIRECT Routing tables status:<inactive>:
Summary count: 1
Destination/Mask
Protocol Pre Cost
DIRECT 0
DIRECT 0
DIRECT 0
Protocol Pre
Huawei Technologies Proprietary
1-10
Chapter 1 Static Route Configuration
Nexthop
0 127.0.0.1
0 127.0.0.1
0 127.0.0.1
Cost Nexthop
Commands
Interface
InLoopBack0
InLoopBack0
InLoopBack0
Interface