Service-Type - Huawei Quidway S3900 series Command Manual

Command Manual – Login
Quidway S3900 Series Ethernet Switches-Release 1510
Description
Use the send command to send messages to a specified user interface or all user
interfaces.
Example
# Send "hello" to all user interfaces.
<Quidway> send all
Enter message, end with CTRL+Z or Enter; abort with CTRL+C:
hello^Z
Send message? [Y/N]y

1.1.18 service-type

Syntax
service-type { ftp | lan-access | { ssh | telnet | terminal }* [ level level ] }
undo service-type { ftp | lan-access | { ssh | telnet | terminal }* }
View
Local user view
Parameter
ftp: Specifies the users to be of FTP type.
lan-access: Specifies the users to be of LAN-access type, which normally means
Ethernet users, such as 802.1x users.
ssh: Specifies the users to be of SSH type.
telnet: Specifies the users to be of Telnet type.
terminal: Makes terminal services available to users logging in through the Console
port.
level level: Specifies the user level for Telnet users, Terminal users, or SSH users. The
level argument ranges from 0 to 3 and defaults to 0.
Description
Use the service-type command to specify the login type and the corresponding
available command level.
Use the undo service-type command to cancel login type configuration.
Commands fall into four command levels: access, monitor, system, and administration,
which are described as follows:
Access level: Commands of this level are used to diagnose network and change
the language mode of user interface, such as the ping, tracert, and
Huawei Technologies Proprietary
1-17
Chapter 1 Login Commands