Huawei Quidway S3900 series Command Manual page 169

Command Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510
Parameter
unit-id: Unit ID, in the range of 1 to 8.
Description
Use the display unit command to display information about the ports on a specified
unit.
Example
# Display information about the ports on unit 1.
<Quidway> display unit 1 interface
Aux1/0/0
Description :
Ethernet1/0/1 current state : DOWN
IP Sending
0012-a990-2240
Media type is twisted pair, loopback not set
Port hardware type is 100_BASE_TX
100Mbps-speed mode, full-duplex mode
Link speed type is force link, link duplex type is force link
Flow-control is enabled
The Maximum Frame Length is 9216
Broadcast MAX-pps: 500
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 1
Mdi type: auto
Port link-type: access
Tagged
Untagged VLAN ID : 1
Last 300 seconds input:
Last 300 seconds output:
Input(total):
Input(normal):
Input:
Output(total): 0 packets, 0 bytes
Output(normal): - packets, - bytes
Aux Interface
Frames' Format
VLAN ID : none
0 packets/sec 0 bytes/sec
0 packets/sec 0 bytes/sec
0 packets, 0 bytes
0 broadcasts, 0 multicasts, - pauses
- packets, - bytes
- broadcasts, - multicasts, - pauses
0 input errors, 0 runts, 0 giants,
0 frame, - overruns, 0 aborts, 0 ignored, - parity errors
0 broadcasts, 0 multicasts, 0 pauses
Huawei Technologies Proprietary
Chapter 1 Port Basic Configuration
is PKTFMT_ETHNT_2,
- throttles, 0 CRC
1-12
Commands
Hardware address is