Ndp Configuration Commands; Display Ndp - Huawei Quidway S3900 series Command Manual

Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510
Chapter 1 HGMPv2 Configuration Commands

1.1 NDP Configuration Commands

1.1.1 display ndp

Syntax
display ndp [ interface port-list ]
View
Any view
Parameter
interface port-list: Specifies a list of ports. The list can contain consecutive or
separated ports, or the combination of the both. You need to provide the port-list
argument in the form of interface-type interface-number [ to interface-type
interface-number ] &<1-10>, where interface-type specifies the port type, and
interface-number specifies the port number (in the form of slot number/port number).to:
Specifies a port range. &<1-10> means that you can provide up to ten port indexes/port
index ranges for this argument.
Description
Use the display ndp command to display the global NDP configuration information,
including the interval to send NDP packets, the holdtime of NDP information, and the
information about the neighbors of all the ports.
Example
# Display NDP configuration information.
<aaa_0.Quidway> display ndp
Neighbor Discovery Protocol is enabled.
Neighbor Discovery Protocol Ver: 1, Hello Timer: 60(s), Aging Timer: 180(s)
Interface: Ethernet1/0/1
Status: Enabled, Pkts Snd: 15835, Pkts Rvd: 2879, Pkts Err: 0
Interface: Ethernet1/0/2
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Interface: Ethernet1/0/3
Status: Enabled, Pkts Snd: 0, Pkts Rvd: 0, Pkts Err: 0
Huawei Technologies Proprietary
1-1
Chapter 1 HGMPv2 Configuration Commands