Timers - Huawei Quidway S3900 series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Parameter
None
Description
Use the summary command to enable RIP-2 automatic route aggregation.
Use the undo summary command to disable RIP-2 automatic route aggregation.
By default, RIP-2 route aggregation is enabled.
Route aggregation can be used to reduce the routing traffic on the network as well as to
reduce the size of the routing table. If RIP-2 is used, route aggregation function can be
disabled with the undo summary command when it is necessary to broadcast subnet
routes.
RIP-1 does not support subnet mask. Forwarding subnet routes may cause ambiguity.
Therefore, RIP-1always uses route aggregation.
Related command: rip version.
Example
# Set RIP version on the interface Vlan-interface 10 as RIP-2 and disable route
aggregation.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] rip version 2
[Quidway-Vlan-interface10] quit
[Quidway] rip
[Quidway-rip] undo summary

2.1.24 timers

Syntax
timers { update update-timer | timeout timeout-timer } *
undo timers { update | timeout } *
View
RIP view
Parameter
update-timer: Value of the Period Update timer, ranging from 1 to 3,600 seconds. By
default, it is 30 seconds.
timeout-timer: Value of the Timeout timer, ranging from 1 to 3,600 seconds. By default,
it is 180 seconds.
Huawei Technologies Proprietary
2-21
Chapter 2 RIP Configuration Commands