Unicast-Suppression - Huawei Quidway S3900 series Command Manual

Command Manual – Port Basic Configuration
Quidway S3900 Series Ethernet Switches-Release 1510
Description
Use the speed command to set the port speed.
Use the undo speed command to restore the port speed to the default setting.
By default, the port speed is in the auto-negotiation mode.
Note that the speed of a Gigabit port can be set to 1000 Mbps or auto-negotiation mode
only.
Related command: duplex.
Example
# Set the speed of Ethernet1/0/1 to 10 Mbps.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface ethernet 1/0/1
[Quidway-Ethernet1/0/1] speed 10

1.1.33 unicast-suppression

Syntax
unicast-suppression { ratio | pps max-pps }
undo unicast-suppression
View
Ethernet port view
Parameter
ratio: Maximum ratio of received unknown unicast traffic to the total bandwidth on the
Ethernet port. The value ranges from 1 to 100 (in step of 1) and defaults to 100. The
smaller the ratio is, the lesser unknown unicast traffic is allowed to be received.
max-pps: Maximum number of unknown unicast packets allowed to be received per
second on the Ethernet port (in pps). The value ranges from 1 to 148,810.
Description
Use the unicast-suppression command to limit the unknown unicast traffic allowed to
be received on the current port.
Use the undo broadcast-suppression command to restore the default unknown
unicast suppression setting on the port.
When incoming unknown unicast traffic exceeds the unknown unicast traffic threshold
you set, the system drops the packets exceeding the threshold to reduce the unknown
unicast traffic ratio to the reasonable range, so as to keep normal network service.
Huawei Technologies Proprietary
1-31
Chapter 1 Port Basic Configuration
Commands