Reset Ndp Statistics - Huawei Quidway S3900 series Command Manual

Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510
Parameter
timer-in-seconds: Interval (in seconds) to send NDP packets ranging from 5 to 254. By
default, the interval to send NDP packets is 60 seconds.
Description
Use the ndp timer hello command to set the interval to send NDP packets.
Use the undo ndp timer hello command to restore the default interval to send NDP
packets.
NDP information in a neighbor information table is updated regularly. This enables
neighbor information table to contain the actual network topology information. You can
use these two commands to adjust the updating frequency of NDP information.
Note that the valid reservation duration of NDP information is larger than the NDP send
interval. Otherwise, it may cause that the NDP neighbor information table becomes
unstable.
Example
# Configure the interval to send NDP packets to be 80 seconds.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ndp timer hello 80

1.1.5 reset ndp statistics

Syntax
reset ndp statistics [ interface port-list ]
View
User view
Parameter
interface port-list: Specifies a list of ports. The list can contain consecutive or
separated ports, or the combination of the both. You need to provide the port-list
argument in the form of interface-type interface-number [ to interface-type
interface-number ] &<1-10>, where interface-type specifies the port type, and
interface-number specifies the port number (in the form of slot number/port number).to:
Specifies a port range. &<1-10> means that you can provide up to ten port indexes/port
index ranges for this argument.
Description
Use the reset ndp statistics command to clear NDP statistics.
Huawei Technologies Proprietary
1-6
Chapter 1 HGMPv2 Configuration Commands