Poe Power-Management - Huawei Quidway S3900 series Command Manual

Command Manual – PoE & PoE Profile
Quidway S3900 Series Ethernet Switches-Release 1510
Use the undo poe mode command to restore the PoE mode on the current port to the
default mode.
By default, the port is powered through a signal cable.
Note that the S3900 series switches do not support the spare mode currently.
Example
# Set the PoE mode on current port to signal.
<Quidway>system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Ethernet 1/0/3
[Quidway-Ethernet1/0/3] poe mode signal

1.1.9 poe power-management

Syntax
poe power-management { auto| manual }
undo poe power-management
View
System view
Parameter
auto: Adopts the auto mode, namely, a PoE management mode based on PoE priority
of the port.
manual: Adopts the manual mode.
Description
Use the poe power-management command to configure the PoE management mode
of port used in the case of power overloading.
Use the undo poe power-management command to restore the default mode.
By default, the PoE management mode on port is auto.
Example
# Configure the PoE management mode on port to auto, that is, adopt the PoE
management mode based on the PoE priority of the port.
<Quidway>system-view
System View: return to User View with Ctrl+Z.
[Quidway] poe power-management auto
Auto Power Management is enabled
# Restore the default management mode.
Huawei Technologies Proprietary
1-10
Chapter 1 PoE Configuration Commands