Rip Authentication-Mode - Huawei Quidway S3900 series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
View
System view
Parameter
None
Description
Use the rip command to enable RIP and enter RIP view.
Use the undo rip command to disable RIP.
By default, the system does not run RIP.
RIP must be enabled before you can enter the RIP view and configure various RIP
global parameters. You can, however, configure the interface-based parameters
regardless of whether RIP is enabled.
Note:
Note that the interface parameters configured previously would be invalid when RIP is
disabled.
Example
# Enable RIP and enter RIP view.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] rip
[Quidway-rip]

2.1.15 rip authentication-mode

Syntax
rip authentication-mode { simple password | md5 { rfc2453 key-string | rfc2082
key-string key-id } }
undo rip authentication-mode
View
Interface view
Parameter
simple: Specifies to use simple text authentication mode.
Huawei Technologies Proprietary
2-13
Chapter 2 RIP Configuration Commands