Snmp-Agent Trap Enable - Huawei Quidway S3900 series Command Manual

Command Manual – SNMP and RMON
Quidway S3900 Series Ethernet Switches-Release 1510
params: Specifies SNMP target host information to be used in the generation of SNMP
messages.
security-string: The community name of SNMP V1 and SNMP V2C, or SNMP V3 user
name, ranging from 1 to 32 characters.
v1: Represents SNMPv1.
v2c: Represents SNMPv2C.
v3: RepresentsSNMPv3.
authentication: Configures to authenticate the packet without encryption.
privacy: Configures to authenticate and encrypt the packet.
Description
Use snmp-agent target-host command to configure destination of SNMP Trap
packets.
Use undo snmp-agent target-host command to cancel the current setting.
The snmp-agent target-host command and the snmp-agent trap enable or enable
snmp trap updown command must be used at the same time on the device to send
Trap packets.
1) Use the snmp-agent trap enable or enable snmp trap updown command to set
Trap packets allowed to send (all Trap packets can be sent by default).
2) Use the snmp-agent target-host command to set the address of the destination
host receiving SNMP Trap packets.
Related command: snmp-agent trap enable, snmp-agent trap source and
snmp-agent trap life.
Example
# Enable sending SNMP Trap packets to 10.1.1.1 with community name public.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] snmp-agent trap enable standard
[Quidway] snmp-agent target-host trap address udp-domain 10.1.1.1 params
securityname public

1.1.19 snmp-agent trap enable

Syntax
snmp-agent trap enable [configuration | flash | ospf [ process-id ] [ ospf-trap-list ] |
standard [ authentication | coldstart | linkdown | linkup | warmstart ]* | system |
vrrp [ authfailure | newmaster ] ]
Huawei Technologies Proprietary
1-17
Chapter 1 SNMP Configuration Commands