Huawei Quidway S3900 series Command Manual page 835

Command Manual – Cluster
Quidway S3100 Series Ethernet Switches-Release 1510
verbose: Displays the detailed information about all the candidate devices.
Description
Use the display cluster candidates command to display the information about the
candidate devices of a cluster. The command is applicable to the management devices
only.
After the cluster is set up, the S3900 switch will collect the topology information of the
network at the set interval and add the detected candidate devices into the cluster
automatically. As a result, if the interval of topology collection is too short (which is 1
minute by default), the switch exists as the candidate device of the cluster for a short
time. If it is unnecessary to add the candidate switches into the cluster automatically,
you can set the interval of topology collection to 0, that is, topology collection is not
performed periodically.
Execute this command on management devices only.
Example
# Display the information about all the candidate devices.
<aaa_0.Quidway-cluster> display cluster candidates
MAC
3900-0000-3334
00e0-fc00-3190
Table 1-6 Description on the fields of the display cluster candidates
command (A)
MAC
Hop
IP
Platform
# Display the information about a specified candidate device.
<aaa_0.Quidway-cluster>
00e0-fc00-3190
Hostname
MAC
Hop
HOP IP
2 16.1.1.11/24
1 16.1.1.1/24
Field
display
: 3900-3
: 00e0-fc00-3190
: 1
Huawei Technologies Proprietary
Chapter 1 HGMPv2 Configuration Commands
PLATFORM
S3900
S3900
MAC address of a candidate
device
Hops from a candidate device to
the management device
IP address of a candidate device
Platform of a candidate device
cluster
1-27
Description
candidates mac-address