Qos-Profile Port-Based - Huawei Quidway S3900 series Command Manual

Command Manual - QoS&QoS Profile
Quidway S3900 Series Ethernet Switches-Release 1510
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] qos-profile a123
[Quidway-qos-profile-a123]

2.1.6 qos-profile port-based

Syntax
qos-profile port-based
undo qos-profile port-based
View
Ethernet port view
Parameter
None
Description
Use the qos-profile port-based command to configure application mode on the port of
the QoS profile.
Use the undo qos-profile port-based command to restore the default application
mode.
By default, user-based application mode is selected on the port.
If the 802.1x authentication is based on the MAC address, you must configure the
QoS profile application mode to be user-based.
If the 802.1x authentication is based on the port, you must configure the QoS
profile application mode to be port-based.
After you configure the QoS profiles and the user pass the authentication, the switch
will deliver the right profile dynamically to the port from which the user is accessed. The
QoS profile can be delivered to the port in these different modes:
User-based mode: If the source station information (source MAC address, source
IP address or source MAC address + IP address) has been defined in the ACL
which is referenced in the traffic actions, the switch cannot deliver the QoS profile;
if no source station information is available, the switch generates a new ACL by
adding the source MAC address and source IP address into the existing ACL, and
then delivers all traffic actions in the QoS profile to the user port.
Chapter 2 QoS Profile Configuration Commands
Huawei Technologies Proprietary
2-5