Command Manual - DLDP
Quidway S3900 Series Ethernet Switches-Release 1510
interface GigabitEthernet1/1/1
dldp port state : advertisement
dldp link state : up
The neighbor number of the port is 1.
1.1.2 dldp
Syntax
dldp { enable | disable }
View
System view, Ethernet port view
Parameter
None
Description
In system view:
Use the dldp enable command to enable DLDP globally on all optical ports of the
switch.
Use the dldp disable command to disable DLDP globally on all optical ports of the
switch.
In Ethernet port view:
Use the dldp enable command to enable DLDP on the current port.
Use the dldp disable command to disable DLDP on the current port.
The commands can apply to a non-optical port as well as an optical port.
By default, DLDP is disabled.
Note:
When you use the dldp enable/dldp disable commands in system view to
enable/disable DLDP globally on all optical ports of the switch, these commands are
only valid for the existing optical ports on the device, however, they are not valid for
those added subsequently.
neighbor mac address : 00e0-fc27-750d
neighbor port index : 98
neighbor state : two way
neighbor aged time : 24
Huawei Technologies Proprietary
Chapter 1 DLDP Configuration Commands
1-2