Mirroring-Group Monitor-Port - Huawei Quidway S3900 series Command Manual

Command Manual – Mirroring
Quidway S3900 Series Ethernet Switches-Release 1510
Description
Use the mirroring-group mirroring-port command to configure the source port.
Use the undo mirroring-group mirroring-port command to remove the configuration
of the source port.
Example
# Configure GigabitEthernet1/1/1 as the source port and mirror all packets received via
this port.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] mirroring-group 1 mirroring-port Gigabitethernet1/1/1 inbound

1.1.6 mirroring-group monitor-port

Syntax
mirroring-group group-id monitor-port monitor-port
undo mirroring-group group-id monitor-port monitor-port
View
System view/Ethernet port view
Parameter
group-id: Group number of a port mirroring group, in the range of 1 to 20.
monitor-port monitor-port: Specifies the destination port for port mirroring.
monitor-port is available in system view only, but not in Ethernet port view.
Description
Use the mirroring-group monitor-port command to configure the destination port.
Use the undo mirroring-group monitor-port to remove the configuration of the
destination port.
Note the following when you configure the destination port:
LACP and TCP must be disabled on the destination port.
The destination port for remote mirroring must be an Access port.
After a port is configured as a reflector port, the switch does not allow you to
change the port type and its default VLAN ID.
Example
# Configure GigabitEthernet1/1/4 as the source port and monitor all packets received
via this port.
Huawei Technologies Proprietary
1-6
Chapter 1 Mirroring Commands