Huawei Quidway S3900 series Command Manual page 34

Command Manual – Login
Quidway S3900 Series Ethernet Switches-Release 1510
language-mode command. The Telnet command is also of this level. Commands
of this level cannot be saved in configuration files.
Monitor level: Commands of this level are used to maintain the system, to debug
service problems, and so on. The display and debugging command are of
monitor level. Commands of this level cannot be saved in configuration files.
System level: Commands of this level are used to configure services. Commands
concerning routing and network layers are of system level. You can utilize network
services by using these commands.
Administration level: Commands of this level are for the operation of the entire
system and the system supporting modules. Services are supported by these
commands. Commands concerning file system, file transfer protocol (FTP), trivial
file transfer protocol (TFTP), downloading using XModem, user management, and
level setting are of administration level.
Example
# Configure commands of level 0 are available to the users logging in using the user
name of "zbr".
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] local-user zbr
[Quidway-luser-zbr] service-type telnet level 0
# To verify the above configuration, you can quit the system, log in again using the user
name of "zbr", and then list the available commands, as listed in the following.
[Quidway] quit
<Quidway> ?
User view commands:
cluster
language-mode
nslookup
ping
quit
super
telnet
tracert
undo
Run cluster command
Specify the language environment
Query Internet name servers
Ping function
Exit from current command view
Set the current user priority level
Establish one Telnet connection
Trace route function
Cancel current setting
Huawei Technologies Proprietary
1-18
Chapter 1 Login Commands