Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] route-policy policy permit node 1
%New sequence of this list
[Quidway-route-policy] apply cost 120
4.1.2 apply tag
Syntax
apply tag value
undo apply tag
View
Route policy view
Parameter
value: Tag value of route information.
Description
Use the apply tag command to configure to set the tag area of route information.
Use the undo apply tag command to cancel the apply clause.
Related command: if-match interface, if-match acl, if-match ip-prefix, if-match ip
next-hop, if-match cost, if-match tag, route-policy, and apply cost.
Example
# Define an apply clause. When it is used for setting route information attribute, it sets
the tag area of route information as 100.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] route-policy policy permit node 1
%New sequence of this list
[Quidway-route-policy] apply tag 100
4.1.3 display ip ip-prefix
Syntax
display ip ip-prefix [ ip-prefix-name ]
View
Any view
Huawei Technologies Proprietary
4-2
Chapter 4 IP Routing Policy Configuration
Commands