Chapter 1 Poe Configuration Commands; Poe Configuration Commands; Display Poe Interface - Huawei Quidway S3900 series Command Manual

Command Manual – PoE & PoE Profile
Quidway S3900 Series Ethernet Switches-Release 1510

Chapter 1 PoE Configuration Commands

1.1 PoE Configuration Commands

1.1.1 display poe interface

Syntax
display poe interface [ interface-type interface-number ]
View
Any view
Parameter
interface-type interface-number: Port on the switch. Refer to Command Manual – Basic
Port Configuration for details.
Description
Use the display poe interface command to view the PoE status of a specific port of the
switch. If the interface-type interface-number argument is not specified, the command
displays the PoE status of all ports of the switch.
Example
# Display the PoE status of Ethernet 1/0/10.
<Quidway> display poe interface Ethernet1/0/10
Port power enabled
Port power ON/OFF
Port power status
Port power mode
Port PD class
port power priority
Port max power
Port current power
Port peak power
Port average power
Port current
Port voltage
:enable
:on
: Standard PD was detected
:signal
:0
:low
:15400 mW
:460 mW
:552 mW
:547 mW
:10 mA
:51 V
Huawei Technologies Proprietary
1-1
Chapter 1 PoE Configuration Commands