Ospf Timer Dead - Huawei Quidway S3900 series Command Manual

Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
between two routers not directly reachable to each other through another router that is
directly reachable to the two routers.
If only two routers run OSPF in the same network segment, the network type of the
interface can also be changed to point-to-point.
Note that you must use the peer command to configure the peer if the network type of
the interface is NBMA or manually changed to NBMA with the ospf network-type
command.
Related command: ospf dr-priority.
Example
# Set the interface Vlan-interface 10 to NBMA type.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] ospf network-type nbma

3.1.40 ospf timer dead

Syntax
ospf timer dead seconds
undo ospf timer dead
View
Interface view
Parameter
seconds: Dead interval of the OSPF neighbor. It is in seconds and ranges from 1 to
65535.
Description
Use the ospf timer dead command to configure the dead interval of the OSPF peer.
Use the undo ospf timer dead command to restore the default value of the dead
interval of the peer.
By default, the dead interval is 40 seconds for the OSPF peers of p2p and broadcast
interfaces and is 120 seconds for those of p2mp and nbma interfaces.
The dead interval of OSPF peers means that, within this interval, if no Hello message is
received from the peer, the peer will be considered to be invalid. The value of dead
seconds should be at least four times of that of the Hello seconds. The dead seconds
for the routers on the same network segment must be identical.
Related command: ospf timer hello.
Huawei Technologies Proprietary
3-44
Chapter 3 OSPF Configuration Commands