Command Manual – Routing Protocol
Quidway S3900 Series Ethernet Switches-Release 1510
Example
# Specify the trans-delay of transmitting LSA on the interface Vlan-interface 10 as 3
seconds.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] interface Vlan-interface 10
[Quidway-Vlan-interface10] ospf trans-delay 3
3.1.45 peer
Syntax
peer ip-address [ dr-priority dr-priority ]
undo peer ip-address
View
OSPF view
Parameter
ip-address: IP address of the peer.
dr-priority: Value of the corresponding priority of a neighbor in the NBMA network. It
ranges from 0 to 255 and defaults to 1.
Description
Use the peer command to configure the IP address of the neighbor router and specify
DR priority on an NBMA network.
Use the undo peer command to cancel this configuration.
Example
# Configure the IP address of the neighbor router as 10.1.1.1.
<Quidway> system-view
System View: return to User View with Ctrl+Z.
[Quidway] ospf 1
[Quidway-ospf-1] peer 10.1.1.1
3.1.46 preference
Syntax
preference [ ase ] value
undo preference [ ase ]
Huawei Technologies Proprietary
3-48
Chapter 3 OSPF Configuration Commands